Visit The Dirt Forum for More Information

Author Topic:   non metric 10 bolt in a metric car
BK19
Dirt Forum Racer

Total posts: 97
posted July 30, 2001 01:14 PM UIN: 40696038
does anyone know how long to cut the upper control arms and where to drill the new holes how far from the front holes do you drill them to mount this in the metric car thanks

Racer4
Dirt Forum Racer

Total posts: 93
posted July 30, 2001 04:26 PM
What rear are you gonna use? A little more info my help here. What type vehicle is the rear from?

BK19
Dirt Forum Racer

Total posts: 97
posted July 30, 2001 07:35 PM UIN: 40696038
it is a 10 bolt with the 8.5 inch ring gear out of a 1976 monte carlo going into a 1982 buick regal

dreamcatcher
Dirt Full Roller

Total posts: 37
posted July 30, 2001 08:32 PM UIN: 14464409
i have done this. cut 1.5 inches off and drill the hole about .75 inches in. be sure to weld large washers on the holes drilled to keep the from whallering out. we have done this several times with great succes. i hope this helps.

Back to the Archives